How To Remove An Interior Door Jamb

How to Remove an Interior Door Jamb

Removing an interior door jamb is a relatively simple task that can be completed in a few hours. By following the steps below, you can safely remove the jamb and replace it with a new one. ### Tools and Materials Before you begin, you will need the following tools and materials: *

Jamb saw

Pry bar

Hammer

Nails

Wood filler

Sandpaper

### Step 1: Remove the Door The first step is to remove the door from the jamb. To do this, open the door and locate the hinges. Using a screwdriver, remove the screws that hold the hinges in place. Once the screws are removed, carefully lift the door off the hinges. ### Step 2: Remove the Hinge Jambs Once the door is removed, you can begin to remove the hinge jambs. The hinge jambs are the vertical pieces of wood that are attached to the door frame and hold the hinges. To remove the hinge jambs, use a jamb saw to cut through the nails that are holding them in place. Be careful not to cut into the door frame. ### Step 3: Remove the Head Jamb The head jamb is the horizontal piece of wood that is attached to the top of the door frame. To remove the head jamb, use a jamb saw to cut through the nails that are holding it in place. Again, be careful not to cut into the door frame. ### Step 4: Remove the Strike Jamb The strike jamb is the vertical piece of wood that is attached to the door frame and holds the strike plate. To remove the strike jamb, use a jamb saw to cut through the nails that are holding it in place. Be careful not to cut into the door frame. ### Step 5: Clean Up the Door Frame Once the jambs are removed, you can clean up the door frame. Use a pry bar to remove any remaining nails or screws. Then, use sandpaper to smooth out any rough edges. ### Step 6: Install the New Door Jamb To install the new door jamb, simply reverse the steps that you used to remove the old one. Start by attaching the strike jamb to the door frame. Then, attach the head jamb and the hinge jambs. Finally, rehang the door. ### Tips Here are a few tips for removing an interior door jamb: * Be careful not to cut into the door frame. * Use a sharp jamb saw to make clean cuts. * If the jambs are stuck, use a pry bar to carefully pry them loose. * Once the jambs are removed, clean up the door frame and install the new jambs.